1. click the CD Drive and select Teneth 440
Teneth_USB-USB DRIVER 64 BIT-double click the URsetup.exe and then install. direct any software installed.
B. The Operating Steps
1. open the Program Corel DRAW and then a desainkan will be on cutting.
2. Once done then select
Tools-Customization-Commands-Macros – Drag Teneth. Teneth on Tool Bar
3. Then choose the symbol that has been a drag on the ToolBar then fill in as follows:
> Page: select the Plotter’s Origin and the contents of the Bottom Left
> Advance Curve: select Resolution and content of 0.0003 Inc. after filled in click OK
4. Then Exit To Teneth Cutter 5.1 and fill in as follows:
> Port: Com 3
> Status: Closed Port
Ploter Compesition >: Offset: 0.25 and Close: 0.25 Then Start